So I'm looking at what I'm going to get for my 2013 Cruze 1LT. It has the tech package (Touch screen) and doesn't have the "premium" 9 speaker setup.
I hope anyone could help me with my questions that I'll have for each parts =P
Haven't ordered yet.
Plan to make a guide from what i learn by doing this.
Major question! How do i get to the stereo!? Through the dash i assume but where are the screws located?
First of all Speakers and Tweeters:
Alpine SPS-610C
Is it feasible to place the tweeters from this into the location where the current front tweeters are?
Rear Door:
Alpine SPS-610
Getting this one with the tweeters built in because i don't think there is a place for separate tweeters on the rear door. Please correct me if i'm wrong.
Speaker AMP:
Stereo:
Stock touch screen
Anyone have a diagram of the back of this? It's the touch screen w/o navigation.
Subwoofer:
AMP:
Alpine MRP-M500
So i noticed on the side with the speaker outputs it has a remote connector. What would i need to connect to that?
Subs:
Enclosure:
Dual 12" Sound ordnance
...feel like i need to put something here xD
Wiring:
EFX 10-Gauge Wire kit
StreetWires Speaker Wires 12-Gauge
Is this all the wiring I'm going to need or is there more?
So some final questions:
I hope anyone could help me with my questions that I'll have for each parts =P
Haven't ordered yet.
Plan to make a guide from what i learn by doing this.
Major question! How do i get to the stereo!? Through the dash i assume but where are the screws located?
First of all Speakers and Tweeters:
Front Door:
Alpine SPS-610C
Is it feasible to place the tweeters from this into the location where the current front tweeters are?
Rear Door:
Alpine SPS-610
Getting this one with the tweeters built in because i don't think there is a place for separate tweeters on the rear door. Please correct me if i'm wrong.
Speaker AMP:
Stereo:
Stock touch screen
Anyone have a diagram of the back of this? It's the touch screen w/o navigation.
AMP:
Alpine MRP-M500
So i noticed on the side with the speaker outputs it has a remote connector. What would i need to connect to that?
Subs:
Enclosure:
Dual 12" Sound ordnance
...feel like i need to put something here xD
Wiring:
EFX 10-Gauge Wire kit
StreetWires Speaker Wires 12-Gauge
Is this all the wiring I'm going to need or is there more?
So some final questions:
Anything i'm missing?
Any recommendations?
What tools do i need?
Any recommendations?
What tools do i need?
Solder Iron
Screw Driver
etc...
Screw Driver
etc...