Fog Light Replacement?

I've been away from the boards for awhile. Got tired of all of the issues with the car, the surging while at a stop light, the distance on my remote start being total crap (20 feet), randomly a buzzing noise from the engine bay.

Now a new issue, which I did not see as a big deal, until I tried to fix it. 2012 LTZ, driver's side foglight is dead, $16 later, new bulb, ready to go...of course, there is all of the plastic panels underneath the car in the way to reach the back of the fog light.

I removed enough bolts to bend the plastic out of the way, get my hand up there, give the bulb a twist and nothing. Looking from the front, I can almost get the bulb turned enough, but at that point I'm straining so hard that I can get the bulb to unlock and I'm afraid the plastic housing is going to break.

This is ridiculous. I'm not even sure that there is enough room to remove the bulb!

Anyone have any tips? I tried the best that I could to twist that bulb so it would unlock but no luck here. I was watching from the front and could clearly see what I was doing.

Another poor design. I really regret buying this vehicle - If I wouldn't take such a bath on selling this car, I'd have another new loaded Silverado